![bullet](_themes/blank/ablbull1.gif) |
Cast Iron and Aluminum Degreasing |
![bullet](_themes/blank/ablbull1.gif) |
Cast Iron bath to remove rust |
![bullet](_themes/blank/ablbull1.gif) |
Sand blasting to remove carbon and
deep rust |
![bullet](_themes/blank/ablbull1.gif) |
Oven baking to remove major grease
and rust |
![bullet](_themes/blank/ablbull1.gif) |
Decking of block for both
straightness and proper squaring |
![bullet](_themes/blank/ablbull1.gif) |
Boring and honing of cylinders for
over sized pistons |
![bullet](_themes/blank/ablbull1.gif) |
Installation of cylinder sleeves |
![bullet](_themes/blank/ablbull1.gif) |
Resizing of main caps |
![bullet](_themes/blank/ablbull1.gif) |
Line boring and honing of mains
for straightness |
![bullet](_themes/blank/ablbull1.gif) |
Line boring and honing of cam
tunnel for proper center and straightness |
![bullet](_themes/blank/ablbull1.gif) |
Lifter Bore bushing installation |
![bullet](_themes/blank/ablbull1.gif) |
Lifter bore honing and resizing |
![bullet](_themes/blank/ablbull1.gif) |
Cam bearing installation |
![bullet](_themes/blank/ablbull1.gif) |
Freeze plug installation |
![bullet](_themes/blank/ablbull1.gif) |
Clearance for stroked crankshaft |
![bullet](_themes/blank/ablbull1.gif) |
Four bolt main cap conversions |